Toshiba Perfecptione Installation And Maintenance Manual page 150

PROGRAMMING PROCEDURES
SECTION 200-255-307
FEBRUARY 1992
TABLE 7-1 (continued)
Error Codes
Program Name: Attendant Data Block (DAlT)
Error Code
ERAT-T 00
ERATT 01
ERA-I-T 02
ERAl-f 03
ERATI- 04
ERAl-F 05
ERA-I-T 06
ERA-I-I- 08
ERA-IT 09
ERA-I-T 10
ERAl-T 11
ERA-I-T 12
ERA-I-T 13
ERA-I-T 14
Meaning
A PCB is not equipped in that location.
The PCB is not an NEKU type.
The port is busy.
The port has already been assigned to a station or DDIU (REQ = NEW).
The port has not been assigned (REQ = CHG, OUT).
Invalid port number.
The entered access code is not assigned to a paging zone or group.
Input data was erased because the program was aborted during NEW data entry.
Attendant data is not assigned to the input port (REQ = CHG, OUT).
The trunk group is already in this priority group.
This is not a valid entry.
The port has already been assigned to a DSS console.
The port has already been assigned to a trunk.
The number of the Attendant Loop Buttons in the Lodging/Health Care mode
cannot be changed.
NOTE:
There is no program to print out the Attendant Data Block.
7-3