Table of Contents
Advertisement
PROGRAMMINGPROCEDURES
SECTION 200-255-310
FEBRUARY1992
When entering AOC in response to TYPE (Table
lo-4), the next prompt will be:
TN0 (Table Number)-Selects
one of 32 area/
office code exception
(AOC) tables.
Enter: 0 - 31 (Table Number).
ARC (Area
Code)--Identifies
the area code to which
this AOC table is assigned.
A maximum
of eight
AOC tables can be assigned
to any area code
(the table numbers
must be sequential).
Enter: Area Code NO/IX or NONE.
NOTE:
N=2-9,
O/l=OorI,
X=0-9.
CNO (Class Number)-Defines
the toll restriction
class numbers
(0 - 7) that are subject to this
exception
table. Any number
of classes, up to a
maximum
of eight,
may be entered.
If a toll
restriction
class table is allowed
to dial an area
code, then all office codes within that specified
area code will be allowed,
except those specifi-
cally added
in response
to the OFC prompt.
If a
toll restriction
class table is not allowed to dial an
area code, all office codes within that specified
area
code
will not be allowed,
except
those
specifically added in response to the OFC prompt.
Enter: Class Numbers
0 1 2 etc. or NONE.
OFC (Office
Codes)-Indicates
the office codes
that are assigned
to this area/office
code excep-
tion table. Office codes may be added or deleted
as single 3-digit codes or as a range covering
up
to ten sequential
3-digit office codes (the area/
office code table is initially blank).
Ranges
are
entered
by using a 4-digit format;
where the first
two digits are common
to all codes in this range;
the third digit represents
the starting
point of the
range (from) for the last digit of the office code;
and the fourth digit represents
the end point of
the range (to) for the last digit of the office code.
See RANGES
example,
CLS sub-program,
OCD
prompt.
Enter: NXXX
NXX NXXX, etc. (in response
to
the A prompt)
to add office codes.
. ..or...
NXXX
NXX NXXX etc. (in response
to
the D prompt)
to delete office codes.
NOTES:
1. N=2-9,X=0-9.
2. Codes cannot be added and deleted in the
same pass through the table. A separate
pass is required for each step.
3. When entering office codes (OFCprompt),
thesystem willprompt %"andanyentries
made willbeadded. To delete office codes,
press the return key @). A "D" will ap-
pear and any entries made will be deleted.
10-6
Advertisement
Chapters
Table of Contents
