Assembling The Drag Mat Carrier - Toro Sand Pro 3040 Manual

Procedure
5
1
Assembling the Drag Mat
Carrier
Parts needed for this procedure:
1 Drag-mat-carrier assembly
1 Attachment-adapter assembly
1 Shoulder bolt
1 Washer (0.531 x 1.063 inch)
3 Washer (0.469 x 0.922 inch)
1 Locknut (7/16 inch)
2 Bolt (3/8 x 2-1/2 inches)
4 Washer (3/8 x 7/8 inch)
2 Spacer
2 Locknut (3/8 inch)
2 Shackle
2 Clevis pin (3/8 x 1-1/2 inches)
2 Cotter pin
Procedure
1. Secure the pivot assembly on the attachment adapter
to the drag-mat carrier with a shoulder bolt, washer
(0.531 x 1.063 inch), washer (0.469 x 0.922 inch) and
locknut (7/16 inch) as shown in
Description
Operator's Manual
Parts Catalog
Clevis pin
Washer (0.469 x 0.922 inch)
Hairpin cotter
Figure 3.
Qty.
1
1
Read the documentation and store the
1
loose parts.
1
1
1. Shoulder bolt
2. Washer (0.531 x 1.063
inch)
3. Pivot assembly
2. Secure the top link of each chain to the back of the lift
arm using a bolt (3/8 x 2-1/2 inches), 2 washers (3/8
x 7/8 inch), a spacer, and a locknut (3/8 inch); refer
to Figure 4.
4
Use
Figure 3
4. Washer (0.469 x 0.922
inch)
5. Locknut (7/16 inch)
6. Drag-mat carrier