Connect Over Wifi To The Local Browser Ui For Initial Configuration - NETGEAR WAX615 User Manual

Insight Managed WiFi 6 AX3000 Access Point Model WAX615
Connect over WiFi to the local browser UI for initial
configuration
This section describes how to connect to the access point for the first time over WiFi
using a WiFi-enabled computer or mobile device (without using the NETGEAR Insight
app) and complete the initial configuration.
To connect over WiFi to the local browser UI for initial configuration:
1. From your computer or mobile device, connect over WiFi to the access point's default
WiFi network.
The default SSID is on the access point label on the bottom of the access point and
is shown in the format NETGEARxxxxxx-SETUP, where xxxxxx is the last six
hexadecimal digits of the access point's MAC address. The default password is
sharedsecret.
2. On the computer or mobile device, launch a web browser and, in the address bar,
enter http://aplogin.net.
Note: You can use http://aplogin.net only during initial setup of the access point.
Your browser might display a security warning because of the self-signed certificate
on the access point, which is expected behavior. You can proceed, or add an
exception for the security warning. For more information, see What to do if you get
a browser security warning on page 39.
3. Enter the access point user name and default password.
The user name is admin. The default password is password. The user name and
password are case-sensitive.
Install the Access Point in Your
Network and Access It for Initial
Configuration
25 User Manual