NETGEAR WAX615 User Manual page 32

Insight Managed WiFi 6 AX3000 Access Point Model WAX615
wireless encryption (OWE). The encryption is set to CCM mode protocol
(CCMP) and 802.11w (PMF) is automatically set to mandatory.
- Allow Clients to Authenticate using Legacy Open (OWE Transition Mode):
If you select the Enhanced Open check box, the Allow Clients to
Authenticate using Legacy Open (OWE Transition Mode) check box
displays. If you select this check box, the WiFi network can accept both clients
that support the WiFi enhanced open feature and clients that do not. For
clients that do not support the WiFi open enhanced feature, traffic is not
encrypted. If you do not select this check box, the WiFi network can only
accept clients that support the WiFi enhanced open feature.
• WPA2 Personal: This option allows only WiFi clients that support WPA2 to
connect to the SSID. Select this option if all WiFi clients are capable of supporting
WPA2. This option uses AES encryption. In the Passphrase field, enter a new
passphrase for the WiFi network.
• WPA2/WPA Personal: This option allows both WPA and WPA2 WiFi clients to
connect to the SSID. This option uses TKIP and AES encryption. Broadcast packets
use TKIP. For unicast (that is, point-to-point) transmissions, WPA clients use TKIP
and WPA2 clients use AES. In the Passphrase field, enter a new passphrase for
the WiFi network.
• WPA3 Personal: This option allows only WiFi clients that support WPA3 to
connect to the SSID. Select this option if all WiFi clients are capable of supporting
WPA3. This option uses SAE encryption. In the Passphrase field, enter a new
passphrase for the WiFi network.
• WPA3/WPA2 Personal: This option allows both WPA2 and WPA3 WiFi clients
to connect to the SSID. This option uses AES and SAE encryption. WPA2 clients
use AES and WPA3 clients use SAE. In the Passphrase field, enter a new
passphrase for the WiFi network.
Note: After you complete the setup process, you can set up WPA2 Enterprise or
WPA3 Enterprise security with RADIUS servers. For more information, see Change
the authentication and encryption for a WiFi network on page 64.
7. Click the Apply button.
Your settings are saved. A pop-up window displays the IP address and the new WiFi
network and password (passphrase).
If you specified a static IP address, save the IP address information because you must
enter the IP address when you log in again.
If you changed the default country, the access point restarts.
Note: Do not close the page!
Install the Access Point in Your
Network and Access It for Initial
Configuration
32 User Manual