Table of Contents
Advertisement
6.0 - Maintenance & Inspection
MAINTENANCE & INSPECTION
1.
Read, understand and follow the Product Manual and all
information located on the product before using, maintain-
ing or inspecting the equipment.
2.
ANSI and OSHA require a regular inspection program for all
fall arrest equipment and to maintain documented results
of these inspections. Follow the inspection procedure
contained in this manual and use the inspection form to
document the results.
6.1 - Maintenance
In general, the Model #TFAT-11A is intended to be a maintenance-free piece of equipment, however several steps can
be taken to keep the system in top-notch working order and also extend the working life of the product.
Before Each Use:
1. Visual Inspection: Perform a complete visual inspection. Refer to section 6.2 for guidelines and take any
maintenance steps that are necessary.
Annually:
1. Clean Product: Use a damp cloth and mild soap to clean the structure and labels of dirt and residue. Be sure
that the labels are legible (replacements are available from Pelsue)
2. Lubricate the threaded screw pegs in order to ensure smooth operation.
3. Complete Inspection: Perform a thorough inspection, paying attention to the bullet points provided within
section 6.2. Record the results and fi le the documentation for future reference. A log sheet has been provided
in section 6.3 specifi cally for the recording of the dates & results of the annual system inspections.
Periodic Factory Service Inspection: It is recommended that the product be serviced by a factory authorized
service center or the manufacturer after a period of three years. Extreme working conditions may indicate
the necessity to increase the frequency. Factory servicing shall include but not be limited to an intensive
inspection and cleaning of all internal and external components. Failure to provide proper service may shorten
product life and could endanger performance or function.
6.2 - Inspection
When completing an inspection of the Model #TFAT-11A Telescopic Fall Arrest Tower, the following specifi c items should
be checked;
1. Labels:
Check that all of the labels are clean and legible (Refer to Section 3.1). Clean the labels if any are dirty using mild
soap and a damp cloth. Replace them if any are illegible. Decals & labels provide valuable warning and caution
information applicable to product usage and limitations, and should be visible and present at all times.
2. Fasteners:
Check that all screws and other fasteners are present and secure. Note that not all fasteners are tightened to their
maximum allowable torque. This is done in order to allow for pivoting and folding motions in certain components.
Over-tightening of fasteners can interfere with the operation of the device and can damage the structure. Consult
the Pelsue Company with any questions regarding fastener torque or specifi cations. All fasteners on the Model
#TFAT-11A system are of a self-locking design. Bolt threads should extend all the way though their locking nuts. If
Page 18
3.
Keep instructional and safety signs clean and legible at
all times. Clean or replace as required.
4.
Remove the equipment from service if a problem is found
during the inspection. Return to an authorized repair depot
or the factory for service.
#500615-001 - Product Manual: Model #TFAT-11A TELESCOPIC FALL ARREST TOWER - Revision 01 - Date: 04-29-2010
Advertisement
Table of Contents
