Advertisement
2
FIT AND SECURE
2.10
2.11
2.12
KSFR002_REV_A03
REMOVE
75mm
205mm
1265mm
1370mm
Starting at the top edge of the vehicle's
windscreen, measure and mark the
dimensions as shown onto both the ditch
LH & RH trim pieces.
Remove the two trim pieces and cut on
each of your markings. Make sure to mark
the various pieces so that you are able to
place them back in their correct positions.
Refit the trim pieces in place using double
sided tape NOT SUPPLIED.
Make sure the ditch & trim is clean before
applying the tape.
Remove the two ditch trim pieces and store
in a safe place. Apply some silicone over
the two rear holes. The two front holes will
be used. Use the universal screw cap, M6 x
20 Button Head, M6 x 12 x 1 Flat Washer
M6 x 19 x 1 Flat Washer & M6 Nyloc Nut
(Items 9, 14, 15, 16 & 17) to seal the 2 rear
holes.
Align the front hole of the Foot Rail with
the front hole in the roof (Indicated by B)
and mark the centre of each slot in the foot
rail on the vehicles roof. Do this with both
LH & RH Foot Rails.
Before drilling into the vehicle assemble
the Slimsport rack and place it on the
vehicle to check for antenna clearance get
a friend to help you (2.16).
Drill the 6 holes you marked earlier,
starting with a 4mm pilot hole before
going to the 6mm hole. There is no need
for a lot of downward pressure. Let the
drill do the work.
Apply anti-rust to all the holes drilled.
3
USA MODELS ONLY
DITCH TRIM OPTION
NO TRIM OPTION
13mm
© 2022 FRONT RUNNER VEHICLE OUTFITTERS
Advertisement
