Advertisement
www.malmsten.com
Connect the bottom frame with hinges using:
1.
Hex socket cap screw (20) – 2 pcs
2.
White plastic washer (30) – 4 pcs
3.
Self-locking nut (28) – 2 pcs
2.5 Attaching the net support pipes
Take the stainless steel connectors (11) and connect them to
the rear bottom frame:
1.
Hex socket button cap screw M8x16 (18) – 4 pcs
2.
M8 square nut (27) – 6 pcs* (3 pcs on each side of the
goal)
* Place two additional M8 square nuts into the groove of the
profile to be used later!
Connect the net pipes (9) to the pre-installed top hinges (12)
using:
1.
Hex socket cap screw M8x60 (19) – 2 pcs
2.
White plastic washers (30) – 4 pcs
3.
DIN 125 A8,4 washer (31) – 2 pcs
4.
DIN 985 M8 nut (28) – 2 pcs
Loctite can be used to permanently lock the bolts in its position.
Malmsten AB • www.malmsten.com
+46 44 28 71 00 • info@malmsten.com
Connect the net pipes (9) to the pre-installed connectors (11) using:
1.
Plastic knob M8 (16) – 2 pcs
2.
Plastic inner knob (17) – 2 pcs
Put the 80x40 mm plastic plug into the profile.
Art. No. 1511026
Advertisement
