Kohler Vintage K-7158 Installation Manual page 5

3. Install Overflow Elbow
- Remove the O rings and lubricant from the package. Apply lubricant
to the O rings.
- Assemble the O rings into the grooves of the overflow elbow.
- Apply more lubricant to the O rings and overflow elbow.
- Insert the overflow elbow into the overflow tube.
- Attach the black gasket to the overflow elbow, as shown.
- Apply a ring of plumbers putty or other sealant, according to the
manufacturer's instructions, to the front side of the gasket (putty will
be between the gasket and the bath).
- Align the overflow elbow with the overflow hole in the bath. From
inside the bath, tighten the retainer nut to the overflow elbow.
- Tighten all coupling nuts on the tee to secure the assembly.
- Apply thread sealant tape to the tailpiece threads.
- Thread the tailpiece onto the tee and tighten securely.
- Make sure the tailpiece on the drain fits properly into the trap. The
tailpiece may need to be cut for proper fit. 1" (2.5cm) to 2" (5cm) of the
tailpiece should fit inside the trap.
Kohler Co.
Black Gasket
Overflow
Elbow
Overflow
Tube
5
A
1018153-2-