Fanimation AIRE DUO LP8066LBN Manual page 14

How to Operate Your Ceiling Fan
2. Restore electrical power to the outlet box by turning
the electricity on at the main fuse box. (Figure 2)
WARNING
Check to see that all connections are tight, including
ground, and that no bare wire is visible at the wire
connectors, except for the ground wire. Do not
operate fan until the blades are in place. Noise and
fan damage could result.
WARNING
Do not operate this fan with a variable (Rheostat) wall
controller or dimmer switch. Doing so could result in
damage to the ceiling fan's remote control unit.
3. To make fan operational, install 23A/12V battery
(included) in hand-held remote transmitte
power off. Then follow the remote code setting
process. (If not used for long periods of time, remove
battery toprevent damage to transmitter). Store the
remote away from excessive heat or humidly.
(Figure 3)
NOTE: The remote unit has 32 different code
combinations. To prevent possible interference from or to
other remote units, simply change the combination code
in the remote and receiver.
4. To set the remote code with a small screwdriver or
ball point pen (neither included), slide dip switches firmly
up or down. (Figure 4)
NOTE: Factory setting is all up. Do not use this position.
5. Remote functions: (Figure 5)
Turns fan on and turns speed up.
Turns fan on and turns speed down.
Increases light output level.
Decreases light output level.
Tap and the fan and light will turn off after
1 hour.
Tap and the fan and light will turn off after
3 hours.
Tap and the fan and light will turn off after
6 hours.
r, with fan
14
(continued)
Figure 2
12V 23A
Battery (1 pcs)
Figure 3
ON DIP
1 2 3 4 5
Dip Switch
Figure 4
Figure 5
MAIN FUSE BOX
Remote