Denon DVD-2910/955 Operating Instructions Manual page 12

Table of Contents

ENGLISH

(3) Connecting to a AV amplifier with a built-in decoder

When DVDs recorded in Dolby Digital or DTS are played, Dolby Digital or DTS bitstream signals are output from the DVD player's digital

audio output connectors. If a Dolby Digital or DTS decoder is connected, you can achieve sound with the power and sense of presence

of a movie theater or concert hall.

DVD-2910/955

Front speaker (left)

Surround speaker (left)

NOTES:

• Harsh noise that could harm your ears or damage the speakers is generated when a DVD recorded in DTS is played while using

a decoder, etc., that is not DTS-compatible.

• When playing copyright-protected linear PCM or packed PCM DVDs, in consideration of copyrights, no digital signals are output

for sources exceeding 48 kHz/16 bits. When playing such sources, either set "LPCM (44.1 kHz/48 kHz)" under "AUDIO SETUP"

at "SETUP" to "ON" (See pages 34, 37.) or make analog connections. (See page 14.)

• When making digital connections to an AV amplifier that is not compatible with 96 kHz/88.2 kHz signals, set "LPCM (44.1 kHz/48

kHz)" under "AUDIO SETUP" at "SETUP" to "ON". (See pages 34, 37.)

• With Super audio CDs, digital audio signals cannot be output from the digital out terminals. Use analog connections. (See page

14.)

2 Connecting an optical fiber cable (commercially available) to the digital audio input connector (OPTICAL)

Line up in proper direction

Line up the cable in the proper directly, then insert it securely as

far as it goes.

75Ω/ohms pin-plug

Optical fiber cable

(or)

cable (commercially

(commercially

available)

Digital audio input

connector (COAXIAL)

connector (OPTICAL)

AV amplifier with a built-in decoder

(AV control center)

Center speaker

Front speaker (right)

Subwoofer

Surround speaker (right)

To power outlet

Table of Contents