Panasonic PT-53WX54J Service Manual page 121

This PTV has a feature that allows to clone convergence and main EEPROM data adjustments from a
PTV to other by connecting a jig to the PTV set. A jig part number TXFJIG01SER, is available through
Matsushita/Panasonic Services.
Preparation:
To connect this jig, remove the lower back cover as instructed on disassembly for service section on
this service manual and insert the jig into A10 connector located on the A-Board. (See figure)
Procedure to copy data:
1. Enter to service mode and display service menu.
2. Select "AREA" DAC and then press ACTION button on remote to enter.
Press VOL right/left to select one of the following options then press
ACTION:
- Select ALL to copy all main EEPROM data
- Select ADJ to copy only adjustment data.
- Select FIX to copy only fix data
3. To copy data from main EEPROM to jig, select "IN
press ACTION button on remote.
4. To copy data from jig to main EEPROM, select "EX
press ACTION button on remote.
Procedure to copy convergence:
1. Enter to service mode and display service menu
2. Select "FINE" DAC and press ACTION on remote.
3. Press "8" on remote.
4. Select from and then press ACTION on remote:
- INT to copy data from internal EEPROM to jig
EEPROM copy jig connection
18
EX" DAC and
IN" DAC and