Remove Fuel Pump - Kohler CV11-16 Service Manual

Section 9
Disassembly
3. Remove the two hex. flange screws and speed
control bracket. See Figure 9-9.
Choke Linkage
Choke
Control
Lever
Hex. Flange Nut
Figure 9-9. Removing Speed Control Bracket.
4. Disconnect the choke linkage from the choke
control lever of speed control bracket.
5. Loosen the hex. flange nut and remove the
governor arm from the cross shaft.
6. Disconnect the fuel line from the inlet fitting of the
carburetor. See Figure 9-10.
Figure 9-10. Removing Fuel Line and Carburetor.
7. Remove the baffle screw and internal tooth washer
securing the ground lead for the fuel solenoid, if so
equipped. See Figure 9-11.
9.4
Speed Control
Bracket
Mounting
Screws
Governor Lever
Gasket
Carburetor
Inlet Fuel Line
Ground Lead
(some models)
Figure 9-11. Removing Baffle Screw and Washer.
8. Remove the carburetor and gasket from the intake
studs.
Remove Fuel Pump (If So Equipped)
WARNING: Explosive Fuel!
Gasoline is extremely flammable and its vapors can
explode if ignited. Store gasoline only in approved
containers, in well ventilated, unoccupied buildings,
away from sparks or flames. Do not fill the fuel tank
while the engine is hot or running, since spilled fuel
could ignite if it comes in contact with hot parts or
sparks from ignition. Do not start the engine near
spilled fuel. Never use gasoline as a cleaning agent.
1. Disconnect the fuel lines from the outlet and inlet
fittings of the fuel pump. See Figure 9-12.
2. Remove the two hex. flange screws, fuel pump,
and gasket.
Hex. Flange
Screws
Gasket
Figure 9-12. Removing Fuel Pump.
Baffle Screw
and Washer
Pump Outlet
Fuel Line
Fuel Pump