Advertisement
The following items are included in your 30T Liberty Phone:
• Handset
• Base (Note: The handset and base are hard-wired together)
• Line cord (Hard wired into base)
• (2) Screws for Wall Mounting
1. Set the volume and ringer controls to the desired levels.
2. Plug the long line cord into the modular baseboard or wall jack. Make sure
the plug snaps securely into place.
NOTE: There is no limit to the number of sockets you
can have installed in your home.
However, there is a limit to the number of telephones you can operate on your
exchange line. Installing too many telephones would overload the line, which
would inhibit the telephones from ringing. To avoid overloading your exchange
line there is a method of calculating the number of telephones you can use. Add all
of the Ringer Equivalence Numbers (abbreviated REN) together, which are marked
on the base of each telephone. Numbers differ so do check. The numbers added
together must total 5 or less.
The REN value of your ClearSounds 30T, is1.0.
1. The switch located above the handset microphone allows the ringer to be
switched On or Off.
2. If you don't like the ringer melody, you can choose a new one by changing
the settings as follows.
Low
Tone 1
Tone 2
Tone 3
The default setting is 6.
3. To set the ringer tone, lift the handset and press the PROG button. Then
press the # button and the number 1-8 on the keypad. (See the chart above.)
WARNING: when the ringer has been set to the off setting (digit 0), an incoming
call will be indicated by the handset strobe light flashing. The ringer will be
automatically returned to the previous setting (1 to 9) when the handset is
lifted from the base unit.
Features & Functions
Connecting the Phone
Med
1
2
4
5
7
8
Components
Ringer
High
3
6
9
Ringer switch
Advertisement
