Table of Contents
Advertisement
Installation Guide
安裝指南
Installation of Washing Machine 洗衣機的安裝
Where to install 安裝地方
Please install on a solid horizontal surface.
請安放在堅硬、平坦的地面上。
• Installation on a slippy or irregular surface may result in noise and shaking.
安放在易於滑動、柔軟的地面上，會容易產生振動和噪音。
Avoid installing the unit too close to the wall.
請勿靠近牆壁安放。
• This is to prevent abnormal vibration and noise.
以防止異常振動和噪音。
How to install 安裝方法
The unit should be installed on a flat horizontal surface.
請水平安裝洗衣機。
Otherwise sudden stop or abnormal sound may occur
during the spinning cycle.
若安裝得不水平，會導致脫水時停機或產生異常聲音。
1
Put the washing machine at the installa-
tion place.
• Make adjustment according to the following steps if
the washing machine is not put on a flat horizontal
surface or there's gap under the leg:
• Heighten the adjustable leg till no gap exists at its side.
•
If there's gap opposite to the adjustable leg, make the rear
leg stand closely on the ground, and insert proper plank
between the front leg and the ground to fill up the gap.
2
Check the bubble location on the horizon-
tal indicator.
• No leg adjustment is required if the bubble is right at
the circle center.
• Adjust height with the adjustable leg if the bubble is
not in the circle.
Installation of the bottom plate 底板的安裝
The bottom plate is placed on the packaging foam on the top of the washing machine.
出廠時，底板安放在洗衣機頂部的包裝發泡上。
1
Please lay down the
washer slowly.
請將機體輕輕地放倒。
8
Circle
Observe the horizontal
indicator from above.
Bubble
2
Align the hook on the bottom plate with the
square hole on the chassis and insert it, and
then tighten the screw.
將底板上的倒鉤對準底盤上的方孔插入，然後擰緊螺釘。
Solid, horizontal surface
堅硬、平坦的地面
At least 1.5cm
1.5cm
At least 9cm(Water drainage hose onside)
At least 1.5cm
9cm
1.5cm
3
According to the bubble location on the
horizontal indicator, rotate the adjust-
able leg to locate the bubble at the
circle center.
If the bubble is out of half of the
circle radius, the ground is too
sloppy to be regulated to flat with
only the adjustable leg.The plank
shall be properly inserted.
4
Check the existence of gap under the
washing machine leg.
• If gap exists, adjust the adjustable leg.
Loosening
Lock nut
Adjustable leg
Elevating
Lowering
5
Remove the horizontal indicator. Close the lid.
Weak surface
Irregular surface
柔軟的地面
凹凸的地面
Attention 注意
• Carpet does not obstruct
the openings for washing
machines with ventilation
openings in the base.
地毯不要堵塞通風口。
plank
Tightening
Lock nut
Advertisement
Table of Contents
