Kodak EasyShare Printer Dock Plus Series 3 User Manual page 69

Transfer button/light
Light status
Light glows steady
green
Light blinks green
Light is off
www.kodak.com/go/support
Cause
The printer dock is ready for
transferring pictures.
Pictures are being transferred
to the computer.
There are no pictures in the
camera or on the memory
card.
The camera is not docked, a
compatible Kodak card reader
is not connected, or a memory
card is not inserted.
The printer dock is not
connected to the computer.
The printer dock is running a
slide show.
The camera is not properly
seated on the connector.
The printer dock is printing in
standalone mode.
The computer is off.
Troubleshooting
Action/solution
None required.
None required.
After transferring pictures, the Transfer
light continues to blink green until
either the Transfer button is pressed
again or the connection is no longer
available.
None required.
To enable Transfer:
1
Connect printer dock to computer
(page 24).
2
Take pictures.
3
Dock the camera or connect a
compatible Kodak card reader
(page 14). If using a card reader,
make sure a memory card is
inserted.
Reseat the camera on the printer dock
(page 8).
The Transfer button is disabled.
Turn on the computer.
62