Kodak EasyShare Printer Dock Plus Series 3 User Manual page 68

Kodak easyshare printer dock plus series 3: users guide
Table of Contents

Advertisement

Troubleshooting
USB device connector light
Light status
Light blinks green Slow blink: the device is
Light is off
Card slot light (SDIO/SD/MMC card behavior)
Light status
Light blinks green
Light is off
61
Cause
initializing or communicating
with the printer dock.
Fast blink: there is a device or
communication error.
There is no device connected to
the USB device connector on the
printer dock.
The connection between the
printer dock and device is loose.
A device other than a compatible
Kodak card reader or PictBridge
compatible camera or device is
connected.
Cause
Slow blink: the internal card
reader is initializing or
communicating with the
printer dock.
Fast blink: there is a card or
communication error.
An SDIO/SD/MMC card is not
inserted or is improperly
inserted in the card slot.
Action/solution
None required.
Check the USB connections from the
device to the printer dock
Disconnect then reconnect USB cable
from printer dock to device.
None required.
Check the USB connections from the
device to the printer dock
Disconnect the device. Connect a Kodak
8-in-1 card reader, or a PictBridge
compatible camera or device.
Action/solution
None required.
Remove the card and make sure the
card is not write protected or damaged.
Replace with a new card if necessary.
Reinsert the card.
None required.
www.kodak.com/go/support
(page
15).
(page
15).

Advertisement

Table of Contents
loading

This manual is also suitable for:

8161960 - easyshare printer dock series 3 photo

Table of Contents