Table of Contents
Advertisement
11
GND
12
DDC data
13
H-sync
14
V-sync
15
DDC clock
24-pin Digital-only DVI Connector
NOTE: Pin 1 is at the top right.
The following table shows pin assignments in the DVI connector:
Pin Signal Assignment
1
T.M.D.S. Data 2-
2
T.M.D.S. Data 2+
3
T.M.D.S. Data 2 Shield 11 T.M.D.S. Data 1 Shield 19 T.M.D.S. Data 0 Shield
4
No Connect
5
No Connect
6
DDC Clock
7
DDC Data
8
No Connect
Universal Serial Bus (USB) Interface
This monitor supports High-Speed Certified USB 2.0 interface.
USB ports:
1 upstream - rear
l
4 downstream - 2 on rear; 2 on left side
l
NOTE: USB 2.0 capability requires 2.0-capable computer.
NOTE: The USB interface of the monitor works ONLY when monitor is powered ON (or in Power Save Mode). Switching your monitor OFF and then ON
would re-enumerate its USB interface; attached peripherals may take a few seconds to resume normal functionality.
Plug and Play Capability
You can install the monitor in any Plug and Play-compatible system. The monitor automatically provides the computer system with its Extended Display
Identification Data (EDID) using Display Data Channel (DDC) protocols so the system can configure itself and optimize the monitor settings. Most monitor
installations are automatic; you can select different settings, if desired.
General
Model number
Flat Panel
Great user manuals database on
Pin Signal Assignment
Pin Signal Assignment
9
T.M.D.S. Data 1-
17 T.M.D.S. Data 0-
10 T.M.D.S. Data 1+
18 T.M.D.S. Data 0+
12 No Connect
20 No Connect
13 No Connect
21 No Connect
14 +5V Power
22 T.M.D.S. Clock Shield
15 Self-Test
23 T.M.D.S. Clock +
16 Hot Plug Detect
24 T.M.D.S. Clock -
Data Rate Power Consumption
High speed 480 Mbps 2.5W (Max., each port)
Full speed
12 Mbps
2.5W (Max., each port)
Low speed 1.5 Mbps
2.5W (Max., each port)
UserManuals.info
SP1908FP
Advertisement
Table of Contents
