Table of Contents
Advertisement
3.4
Drive mounting
Users can mount the drive in any orientation using four screws in the side-mounting holes or four screws in the bottom-mounting holes.
See
for drive mounting dimensions. Follow these important mounting precautions when mounting the drive:
Figure 3
• Allow a minimum clearance of 0.030 in (0.76mm) around the entire perimeter of the drive for cooling.
• Use only 6-32 UNC mounting screws.
• The screws should be inserted no more than 0.140 in (3.56mm) into the bottom or side mounting holes.
• Do not overtighten the mounting screws (maximum torque: 6 in-lb).
3.4.1
Mechanical specifications
Refer to
for detailed mounting configuration dimensions. See
Figure 3
Weight:
10TB & 8TB models
These dimensions conform to the Small Form Factor Standard documented in
Note
SFF-8301 and SFF-8323, found at
6X 6-32 UNC-2B
.169 .010 x 90
3 MIN THREAD DEPTH
.14 MAX FASTENER PENETRATION
MOUNTING HOLES
MAX TORQUE: 6 IN-LBF
2X 3.000±.010
2X 1.750±.010
2 2X 1.432±.020
2X 1.625±.020
3X .125±.010
Figure 3.
Mounting configuration dimensions 5-disk models
The image is for mechanical dimension reference only and may not represent the actual drive.
Note
Seagate IronWolf Serial ATA Product Manual, Rev. A
www.sffcommittee.org
C L OF DRIVE
C L OF CONN
2 .814±.020
3X 3.750±.010
C L OF DRIVE
TEMPERATURE
CHECKPOINT
2.000
60 C MAX
3.4, "Drive mounting."
Section
1.587 lb
720g
4.000±.010
1.638±.010
1.122±.020
3X .250±.010
BOTH SIDES
6X 6-32 UNC-2B
.160 .010 x 90
3 MIN THREAD DEPTH
.14 MAX FASTENER PENETRATION
MOUNTING HOLES BOTH SIDES
MAX TORQUE: 6 IN-LBF
2 .138±.015
1.028 MAX
[26.10MM]
5.787 MAX
147.00 MM
4.000±.010
21
Advertisement
Table of Contents
