2.3
Recording and interface technology
Interface
Recording method
Recording density, KBPI (Kb/in max)
Track density, KTPI (ktracks/in, 0 Skew)
2
Areal density (Gb/in
, @ 0 skew mid-disk)
Spindle speed (RPM) (± 0.2%)
Internal data transfer rate (Mb/s max)
Sustained data transfer rate (MiB/s max)
I/O data-transfer rate (MB/s max)
2.4
Start/stop times
Power-on to ready time is based on typical operating conditions, default full current spin-up profile, and clean shutdown prior to
measurement. To ensure a clean shutdown a Flush Cache, Standby, or Standby Immediate command must be completed before
removal of interface power.
Power-on to Ready (sec) (typ/max)
Standby to Ready (sec) (typ/max)
Ready to spindle stop (sec) (max)
An unexpected power loss event, spin up at cold or hot temperature extremes may cause the drive to exceed the typical and max
time to ready by 5 to 20 seconds. Extended time to ready is dependent on cache state and environmental conditions prior to the
unexpected power loss and during the subsequent power on.
Seagate IronWolf Serial ATA Product Manual, Rev. A
Serial ATA (SATA)
Perpendicular
2499
487
1215
7200
2169
200 (210 MB/s max)
600 (Ultra DMA mode 5)
23/30
23/30
20
8