Connecting To The Battery; Charging Modes - BorMann PRO BBC4010 Instruction Manual

EN
LCD ICONS:

Connecting to the battery

1. Identify polarity of battery posts. The positive battery terminal is typically marked by these letters or symbols (POS,P,+). The negative battery terminal is typi-
cally marked by these letters or symbols (NEG,N,-).
2. Do not make any connections to the carburetor, fuel lines, or thin metal parts.
3. Identify if you have a negative or positive grounded vehicle. This can be done by identifying which battery post (NEG or POS) is connected to the chassis.
4. For a negative grounded vehicle (most common): connect the RED POSITIVE clamp first to the positive battery terminal, then connect the BLACK NEGATIV
clamp to the negative battery terminal or vehicle chassis.
5. For a positive grounded vehicle (very uncommon): connect the BLACK NEGATIVE clamp first to the negative battery terminal, then connect the RED POSITIVE
clamp to the positive battery terminal or vehicle chassis.
6. When disconnecting, disconnect in the reverse sequence, removing the negative first (or positive first for positive ground systems).
7. A marine (boat) battery must be removed and charged on shore. To charge it on board requires equipment specially designed for marine use.

Charging modes

Ιmportant Note:
The BBC4010 charger has 10 modes: Standby, 12V STD, 12V COLD/AGM, 12V LITHIUM (LIFEPO4), 12V CAL, 6V STD, 6V COLD/AGM, 6V CAL , REPAIR, 12V AL-
TERNATOR CHECK. Do not operate the charger until you confirm the appropriate charge mode for your battery. CAUTION: If you choose 12V Mode(s) for 6V
battery, the 6V battery will be damaged!
Mode Battery Size (Ah)
Standby
12V STD
12V COLD/AGM
12V CAL
6V STD
6V COLD/AGM
6V CAL
12V LITHIUM
REPAIR
12V ALTERNATOR CHECK
The following modes are advanced charging modes that require your full attention before selecting.
3
Charging current display/battery voltage display/battery function display
Generator detection display
Battery health
percentage display
Short circuit
warning and battery
Ordinary lead-acid
battery
Battery voltage to
start charging
Low temperature charging
mode and AGM battery type
- Not charging or providing any power. The user can check the Remaining Battery Capacity (State of Charge)
2-120 Charging 12V STD batteries
2-120 Charging 12 V batteries below 10
2-120 Charging 12 V CAL batteries
2-120 Charging 6 V STD batteries
2-120 Charging 6 V batteries below 10
2-120 Charging 6 V CAL batteries
2-120 Charging 12 V lithium-ion (LiFePO4) batteries only
2-120 An advanced battery recovery mode for repairing old, idle, stratified or sulfated batteries
2-120 Check vehicle's alternator output
WWW.BORMANNTOOLS.COM
Battery repair function
(LiFePO4 12V lithium battery
Total capacity of fully Total time required for
charged battery charger charging
Explanation
C (50 F) or 12V AGM battery
o o
C (50 F) or 6V AGM battery (Green LED)
o o
Battery charging
dynamic display
Battery voltage
type display
4 Cell LiFePO4)
Battery capacity to
start charging