Table of Contents
Advertisement
WARNING! To prevent serious injury, make sure all the instructions have been read and understood before
operating this tool. Before plugging the machine into the power supply, always check that the trigger switch and
trigger lock work properly.
USING THE SAFETY KICKSTAND
The safety kickstand (Fig. 1 - 1) on the back of the planer swings
down to help keep the blade from coming into contact with the
work surface when the planer is not in use.
To use the safety kickstand when the planer is not in use, slide the
stand until it springs out. Push the kickstand back into the slot and
slide it back until it locks into place before operating the planer.
CONNECTING THE DUST BAG
If desired, attach the dust bag by sliding the nozzle onto the chip
extraction port (Fig. 2 - 1). For efficient operation, empty the dust
bag when it is no more than half full, allowing for better airflow
through the bag.
You can also connect your planer to a suitable dust extraction sys-
tem through the extraction port. Hose adaptors (not included) may
be needed depending on the size of your dust hose. The chip ex-
traction port's outer diameter is 1-9/16" (39.5mm); the inner diam-
eter is 1-5/16" (33.5mm).
WARNING! Shavings may jam in the dust extraction port
when cutting damp wood. Never stick your finger into the dust
extraction port. Clean out the shavings with a stick, but only
when the cutter has stopped running and the tool has been un-
plugged from the power source.
SWITCHING ON AND OFF
The tool is equipped with a trigger lock (Fig. 3 - 1) to avoid uninten-
tional start-ups.
1. To turn the planer on, press the trigger lock (Fig. 3 - 1) and then
squeeze the trigger switch (Fig. 3 - 2).
2. To switch off, release the trigger switch.
12
OPERATION
1
1
Fig. 1
1
Fig. 2
Fig. 3
2
Advertisement
Table of Contents
