Kodak DCS 330 User Manual page 42

Serial In Mode
When the serial port is in Serial In mode, your camera accepts text strings from a
connected external device. The information is then added to specified image headers.
Menu
Choice
None No data received
New Images The text string from the
connected device is written to
the header of subsequent
images.
Previous A text string from the connected
Image device is written to the header of
previously captured image file.
GPS A text string from the connected
GPS device is written to the
header of the just-captured
image file.
Remote An image is captured when you
Release activate the connected remote
cable release.
Modem Reserved for Transmit option
(page 42)
1
2
Action
Serial port is unavailable.
Text string must be 250 valid
characters, or less. Valid characters
consist of ASCII characters, carriage
return, and line termination.
When you select New Images or
Previous Image, a Serial In Status
option (page 40) becomes available.
If a Trimble GPS card is inserted in the
camera (page 29), the serial port GPS
functionality is over-ridden by the
Trimble card.
Use the remote release to minimize
camera movement or when you are
away from the camera. Contact your
service representative regarding a
cable, if needed.
Set automatically when you use the
Transmit option.
39
Select Serial In from the Serial
Port menu (page 38).
The Serial In Mode menu
appears.
Select your choice (described in
the table below).
The setting is retained until you
change it, disconnect the device,
or use the Transmit option (page
42). Modem is selected
automatically with this option.
Comments