Table of Contents
Advertisement
NL Troubleshooting
Malfunction
Program centrifugal
run does not start.
fizzing, hissing
loud.
Loud noise during
spinning.
Clapping, clattering
in the pump.
Slurping, rhythmic
suction sound.
wrinkling.
Detergent or laundry detergent
softer drips from
the cuff and collects
on the door or in the
cuff fold.
Spin result is
not to satisfaction-
ness. The laundry is
too wet / too damp.
64
Cause and Troubleshooting
Remark: If possible, place large and small items of
laundry together in the drum. Laundry of different
sizes is more evenly distributed when spinning.
Start the program Centrifuge.
▶
Water is flushed into the detergent drawer under
pressure.
No error - normal operating noise.
▶
The appliance is not leveled properly.
Adjusting the device
▶
Device feet are not fixed.
Secure the device feet. Setting the appli-
▶
raat
Transport protections have not been removed.
Remove transport locks
▶
A foreign object has entered the pump.
→ " Cleaning the drain pump", page 52
▶
Pump is active, the water is being pumped out.
No error - normal operating noise.
▶
Spin speed is too high.
For the next wash, set a lower spin
▶
speed in.
The load quantity is too high.
During the next wash, reduce the load
▶
amount of.
The wrong program has been selected for the type of
fabric.
Select a suitable program for the type of fabric.
▶
→ "Programs", Page 26
Too much detergent/fabric softener in the detergent
drawer.
When dosing the liquid detergent and
▶
fabric softener on the marking in the detergent drawer
and do not dose above that.
Low spin speed is set.
For the next wash, set a higher spin
▶
speed in.
Start the program Centrifuge. Anti
▶
wrinkleis activated.
Advertisement
Table of Contents
