Advertisement
Contents
Connections
Tactile Transducer Setup
Set the level and low pass filter cutoff frequency when using tactile
transducers.
o Tactile Transducer
Sets the tactile transducer option.
Enabled:
Disabled
(Default):
0 For Tactile Transducer connections, use the Subwoofer 4 PRE OUT
connector.
0 This can not be set when "Speaker Configuration" - "Subwoofer" is set to "4
spkrs".
o Level
Adjusts the volume of the tactile transducer output.
–12.0 dB – +12.0 dB (Default : 0.0 dB)
0 The "Level" are reflected in all input sources.
0 If you wish to adjust the tactile transducer level for each input source, carry out
the settings in "Tactile Transducer". (v p. 121)
Front panel
Display
Playback
Enables tactile transducers.
Disables the tactile transducers.
Rear panel
Settings
o Low Pass Filter
Selects the low pass filter cutoff frequency for the tactile transducer
output.
40 Hz / 60 Hz / 80 Hz / 90 Hz / 100 Hz / 110 Hz / 120 Hz / 150 Hz /
180 Hz / 200 Hz / 250 Hz (Default: 80 Hz)
The "Low Pass Filter" are reflected in all input sources.
0
227
Remote
Tips
Appendix
Index
Advertisement
