Removing And Fitting The Battery - Stihl FSA 90 Instruction Manual

9 Removing and Fitting the Battery

► Loosen the wing screw (1).
► Swing the bike handle (2) to the required posi‐
tion.
► Tighten down the wing screw (1) firmly.
FSA 90 R
The loop handle can be set to different positions
to suit the height and reach of the user.
► Switch off the brushcutter, push the retaining
latch to position and remove the battery.
► Undo the screws (2).
► Move the loop handle (1) to the required posi‐
tion and check that the following conditions
are met:
– If you are using a mowing head: a = no
more than 30 cm
– If you are using a metal cutting attachment:
a = no more than 25 cm
► Tighten down the screws (2) so that the loop
handle (1) cannot be rotated on the shaft.
8.3 Balancing the Trimmer
The cutting attachment should rest lightly on the
ground.
0458-709-9921-C
2
1
a
1
2
► Switch off the trimmer and push retaining latch
to position .
► Connect the carrying ring (1) to the carabi‐
ner (2).
► Wait for the trimmer to stop swinging.
► Check position of cutting attachment. If it
needs adjustment:
3
► Loosen the screw (3).
► Move carrying ring (2) up or down the drive
tube until correct balanced position is reached.
► Tighten down the screw (3) firmly.
9 Removing and Fitting the
Battery
9.1 Inserting the battery
1
2
► Insert the battery (1) up to the limit stop into
the battery compartment (2).
The battery (1) engages with a click and is
now locked.
9.2 Removing the Battery
► Stand the trimmer on a level surface.
► Hold one hand in front of the battery compart‐
ment to ensure the battery (2) does not fall
out.
English
1
2
2
37