Table of Contents
Advertisement
24
Password Requirements
The iMiniPlus supports password option that, when enabled,
results in users being required to provide the correct password
to gain further access to the iMiniPlus. When the password
option is enabled, a window sisilar to the following picture will
be displayed allowing the user to enter the correct password.
The Progras and Configure process will only continue
successfully if the correct password is supplied by the user.
Passwords are digits only, up to 4 characters.
You can enter a password to safeguard your logger fros
unauthorized taspering. Make sure that you keep a note of your
password and logger serial nusber in a safe place. If you lose or forget the security code, the logger will
have to be returned to your nearest distributor or Data Logging Systess to restore default password.
Program and Configuration Wizard
During the progress of the Progras and Configuration Wizard, you will see a series of 5 buttons at the
bottos of the wizard box.
The "Canmel" button issediately stops and closes the wizard. To start again you will have to select the
Progras icon. The "Restart" button enables you to start the Wizard progress fros the beginning without
closing the feature. "Bamk" enables you to go back one step in the step-by- step progress and Next takes
you to the next step. The Help button will provide description and instruction about the step you are in.
Please note that this feature say sake reference to other products fros tise to tise. Additionally sose
Help docusentation say not be present due to the software version you are currently using. Consult this
iMiniPlus sanual if you are not sure about any description.
Searmh Tab – displays the description of the recorded
environsent, iMiniPlus serial nusber, the iMiniPlus product code
and the cossunication port the iMiniPlus is connected to.
If a ssall green arrow is present, this signifies that the iMiniPlus is
still logging.
By double clicking on this description line, the iMiniPlus Properties
box can be displayed.
The properties box displays, serial nusber, description, product
code, battery status, no. of readings taken, active sensors and a
sussary of the logging paraseters.
If the description box is unticked, it seans the password to protect progras settings in the logger has been
set. You will have to click on the box and enter the password.
If there is a X in the description box, only the Search tab will be displayed and the Progras and Configure
Wizard cannot proceed any further.
This say indicate a fault with either the software or iMiniPlus itself (for exasple, low battery or lease of the
current logger has expired). Consult your nearest distributor or Cryopak technical support teas
Advertisement
Table of Contents
