Initial Commissioning The Axial-Piston Motor/Axial-Piston Motor Connection; Initial Commissioning The Electric Motor Connection; Before Filling The Planetary Gearbox With Lubricating Oil - Bosch Rexroth 40 Series Operating Instructions Manual

40/64 Commissioning
Bosch Rexroth AG, MOBILEX GFB 8000 series 40 general operating instructions, RE 79039-01-B/01.2021

8.1.1 Initial commissioning the axial-piston motor/axial-piston motor connection

If the planetary gearbox is delivered with an axial-piston motor or with a
connection to attach an axial-piston motor:
With delivered axial-piston motor, strictly observe the instructions of the axial-

piston motor operating instructions. You will find these in appendix C
"Mounting parts" in the material number-specific operating instructions of the
planetary gearbox.
If Rexroth delivers the hydrostatic swing drive without axial-piston motor, the
operating instructions of the motor are not included in the scope of supply.
Observe the operating instructions of the axial-piston motor (provided by the
manufacturer of the axial-piston motor). This is where you will find all the
required information on assembly and commissioning of the axial-piston motor.

8.1.2 Initial commissioning the electric motor connection

If the planetary gearbox is supplied with a connection for mounting an electric
motor:
If Rexroth delivers the hydrostatic swing drive without electric motor, the
operating instructions of the motor are not included in the scope of supply.
Observe the operating instructions of the electric motor (provided by the
manufacturer of the electric motor). This is where you will find all the required
information on assembly and commissioning of the electric motor.

8.1.3 Before filling the planetary gearbox with lubricating oil

This chapter describes how to fill the planetary gearbox with lubricating oil.
In order to fill the planetary gearbox with lubricating oil, you need the following
fundamental information:
Refer to the dimensioned drawing for:

• Position of the oil filler opening
• Position of oil level control system (oil dipstick)
• Position of the oil drain opening
Refer to the selection list – industrial gear oils for:

Approved lubricating oils
–
Refer to the technical data for

Lubricating oil viscosity and oil quantity
–
 Always record the used oil designation.