MDT KNX SCN-RT1UP.01 Technical Manual page 10

Technical Manual – Room Temperature Controller SCN-RT1
20 Guiding value
21 Max memory value
22 Min memory value
23 Min/Max memory
reset
24 Reset setpoint value
25 DPT_HVAC Status*
28 Error external Sensor
29 Actual setpoint
30 DPT_RHCC*
31 Mode selection
Table 2: Communication objects – default settings
You can see the default values for the communication objects from the upper chart. According to
requirements the priority of the particular communication objects as well as the flags can be
adjusted by the user. The flags allocates the function of the objects in the programming thereby
stands C for communication, R for Read, W for write, T for transmit and U for update.
* from version 1.2
MDT technologies GmbH • 51766 Engelskirchen • Papiermühle 1
10
Phone: +49-2263-880 • Fax: +49-2263-4588 • knx@mdt.de • www.mdt.de
Setpoint adjustment
Read memory
Read memory
Reset memory
Parameter read in
Send controller status
Error message
Send setpoint
Send controller status
Select mode
2 Byte Low
2 Byte Low
2 Byte Low
1 Bit Low
1 Bit Low
1 Byte Low
1 Bit Low
2 Byte Low
2 Byte Low
1 Byte Low
X X X
X X X X
X X X X
X X X
X X
X X X
X X X
X X X
X X X
X X X