Stiga Cruiser 430 Li 60 Series Operator's Manual page 125

Adjust the cutting height as indicated in (par. 5.3).
6.1.4 Handle inclination adjustment (Fig.3/4)
Do this when the cutting means is stationary.
6.2 SAFETY CHECKS
Run the following safety checks and check that the
results correspond to those outlined on the tables.
Always carry out the safety checks before use.
6.2.1 General safety check
Object
Grips
Handle
Cutting means
Rear discharge guard;
grass catcher
Side discharge guard,
side discharge chute
Control lever
Drive lever
Battery
Screws/nuts on the
machine and on the
cutting means
Cooling air ducts
Machine
6.2.2 Machine operating test
Action
1. Start the machine
(par. 6.3).
2. Release the switch
control (Fig. 19.A).
Result
Clean, dry.
Fixed firmly to the machine.
Clean, not damaged
or worn.
Good condition. No
damage. Properly installed.
Good condition. No
damage. Properly installed.
The lever must move
freely, it must not need
forcing and should
return automatically
and rapidly back to
the neutral position.
No damage to the casing,
no liquid leakage.
Correctly tightened
(not loose).
Not clogged.
No signs of damage
or wear.
Result
1. The cutting means
should move.
2. The lever should auto-
matically and quickly
return to neutral posi-
tion, the engine must
switch off and the cut-
ting means must stop
within a few seconds.
1. Start the machine
(par. 6.3).
2. Engage the drive
lever (par. 5.2.2 ).
3. Disengage the
drive lever.
Test driving
If any of the results fail to match the indications
provided in the tables, do not use the machine! Contact
a service centre to have it checked and repaired if ne-
cessary.
6.3 START-UP
NOTE Start up the machine on a flat
surface without obstacles or high grass.
1. Open the hatch for accessing the battery com-
partment (Fig.15.A).
2. Insert the battery (Fig.15.B) in its housing pres-
sing down until you hear it clicks firmly into
position, in ensuring the electrical contact.
3. .Insert the safety key (Fig.15.C).
4. Completely close the hatch again.
5. Press the safety button (Fig.16.A) and
pull the control lever (Fig.16.B).
6.4 OPERATION
IMPORTANT When working, always keep
a safe distance from the cutting means,
given by the length of the handle.
Battery power reserve (and therefore the movable
lawn surface before recharging is required) depends
on many factors described in (par. 7.2.1).
IMPORTANT If the motor stops because
it is overheated while mowing, you must wait
approximately 5 minutes before restarting it.
6.4.1 Grass cutting
1. Start moving forward and mowing in the grass area.
2. Regulate the forward speed and the cutting
height (par. 5.4) considering the conditions of
the lawn (the height, density and dampness of
the grass) and the amount of grass collected.
On models equipped with feed rate
adjustment (Fig. 9.B): We recommend not
to work land that slopes more than 15°.
EN - 7
1. The wheels should
move the machine
forward.
2. The wheels should
stop and the machine
stops moving forward.
No abnormal vibrations.
No abnormal sound.