Subscribe to Our Youtube Channel
Related Manuals for Soozier A90-327V80
Summary of Contents for Soozier A90-327V80
- Page 1 INapb006_US A90-327V80 TREADMILL IMPORTANT, RETAIN FOR FUTURE REFERENCE: READ CAREFULLY UESR’S MANUAL...
-
Page 2: Safety Notice
1. CAUTION To avoid injury, please read this manual carefully before using. For safety purposes, never start the treadmill when you are standing on the running belt. If you feel faint, ill or nauseous, please stop using immediately. Please adjust the speed slowly. Do not adjust the belt during use. -
Page 3: Caution During Use
3. CAUTION DURING USE If you do not feel well before using, please seek medical advice. Our company assumes no responsibility for personal injury or property damage by or through the use of this product. Always unplug this product after use. When moving, cleaning or doing maintenance, ensure the product is unplugged. -
Page 4: Control Panel
5. Control Panel (1) Display 1.1 TIME: Two modes which display the running time. ① Time will count from 0:00 to 99:59 minutes. ② To set a countdown timer, the range is between 5:00-99:00 minutes. When it reaches ‘00:00’, the machine will slowly stop and display ‘end’. The machine will enter standby after five seconds. -
Page 5: Using The Remote Control
(2) Using the remote control Power button. (1) In standby or countdown mode: Press the power button to start the machine. Note: The default speed is 0.5km/h. (2) Choosing the preset programme: Press the power button to start the machine – the speed will change according to the preset speed. - Page 6 machine will stop automatically once it reaches 0. 3.3 Preset programme (P01-P12): Choose one programme first, then press + or - to set the running time (5:00-99:00 mins. The default time is 30:00 mins). Press the power button to start the machine, which will run according to the preset speed. The speed will change according to the time ‘(Time/20)’.
-
Page 7: Daily Maintainance
8. Run belt Adjustment (1) Deviating the running belt to the left Start the machine at 2-3KM/h without loading. Use a die nut to screw a 1/4 circle (Fig 1). Let the machine run without getting on for 1-2 minutes. Use these same instructions, so the belt goes back into the middle. -
Page 8: 10.Troubleshooting
10.Troubleshooting Error Meaning Problem Solution Code Control board or wires Control Board Error. Replace control board. are damaged. Control Board Error. Control board is broken. Replace control board. 1. Open the motor cover and check Control board has a whether the motor is blocked. Remove Overcurrent Protecti short circuit or the motor anything blocking the motor.
Need help?
Do you have a question about the A90-327V80 and is the answer not in the manual?
Questions and answers