Appendix: Front Panel; Ni-7932R Front Panel - National Instruments 7932 Manual

Firewall » Allow a program through Windows Firewall. Click Allow another
program, select Measurement & Automation, click Add, then click OK.
Ensure that UDP port 44525 is open to communication on the host
■
computer. If you are using an intelligent switch on the network, ensure that it
is not disabling UDP port 44525.
Hold down the RESET button for 5 seconds to reboot the target into safe
■
mode. This prevents a real-time app from running. Sometimes a
malfunctioning real-time app prevents network communication.
Check the Device Manager to ensure the National Instruments USBLAN
■
adapter is recognized. In Windows 7, select Start » Control Panel » Device
Manager » Network adapters » National Instruments » USBLAN adapter. If the
USBLAN adapter is not recognized, you must reinstall FlexRIO Support.
Ensure that the Ethernet cable is connected correctly.
■
Related tasks
Configuring the System in Measurement & Automation Explorer (MAX)
■

NI-7932R Front Panel

The following figure shows the NI-7932R front panel connectors, buttons, and LEDs.
NI-7932
17
© National Instruments