Tumbl Trak Addie Balance Beam Assembly Instructions

Assembly Instructions

Addie Balance Beam

Thank you for investing in the Tumbl Trak Addie Beam. Train leaps, turns, handstands and much more. Open

box carefully and check to make sure all parts have arrived. After opening the boxes, please check the parts list

to make sure all pieces have arrived in good condition.

Step 1

Step 2A

Step 2B

Step 3

Any questions or problems, please call Tumbl Trak at 800.331.4362 or email us at sales@tumbltrak.com

STEP 1 – Flip the beam upside down and locate the two outside screw holes on each end of

the beam. Place the feet on the beam, line up the screw holes with the tapered holes facing up.

*The inner set of holes are intended for leg risers.

STEP 2 — (2A) Insert the screw through the star washer. (2B) Place the

screws in the tapered holes connecting the feet to the beam.

STEP 3 – Use the Allen Wrench and turn screws unill the feet

are tightly secured to the beam.

Parts List

Parts:

A. Suede covered beam

B. (2) Rubber coated feet

C. (4) Screws

D. (4) Star washer

Allen Wrench

Table of Contents

Do you have a question about the Addie Balance Beam and is the answer not in the manual?

Page 1 Allen Wrench Thank you for investing in the Tumbl Trak Addie Beam. Train leaps, turns, handstands and much more. Open box carefully and check to make sure all parts have arrived. After opening the boxes, please check the parts list to make sure all pieces have arrived in good condition.
Page 2 Be sure to save the two short legs in case you’d like to use them again in the future. Recommended Accessories Tumbl Trak recommends the use of matting to enhance safety. The following accessories can be purchased from Tumbl Trak’s website at www.tumbltrak.com or by calling 1-800-331-4362.