Tumbl Trak Brianna Beam Assembly Instructions

Assembly Instructions
Thank you for purchasing the Brianna Beam. We
hope you will enjoy years of use of this product.
After opening the boxes, please check the parts
list to make sure all pieces have arrived in good
order. If you have any questions during this
assembly process, please call customer service
at 44 (0)2921 167 949.
1
Remove
contents from
box and lay
out as shown
2
Align legs with Velcro
on the bottom of the
beam
If you purchased two or more Brianna Beams
you can connect them together!
4
Find the wooden
peg that was
included with your
shipment and
open the Velcro
flaps at the end of
both beams to
expose the holes
6
Slide the two beams
together
3
Flip the beam over
and slide the beam
into the legs. You
may have to push
down hard
Note: Enclosed is a small
vinyl sheet that will
Velcro to the bottom of the
beam legs. This will
eliminate the full amount of
Velcro, on the legs, from
damaging to your carpet.
5
7
Secure the Velcro straps on
the sides of the beam
No tools needed!
Place the
peg in the
hole of
one beam
Available in
Purple, Pink
or Royal Blue