If You Need Assistance; If You Need Service; Maintenance - KitchenAid KDRP467KSS Installation Instructions Manual

19.
Check operation of oven
element. Turn oven selector to "BAKE".
"350F" will show on display. Press "Enter".
First Preheat light comes on when oven
temperature begins to rise. When second
Preheat light comes on, open oven door
and hold hand above oven floor and feel
for heat. DO NOT TOUCH OVEN FLOOR.
Press "Cancel" and turn oven selector to
"Reset".
20.
Check the operation of the
broiler element. Turn oven selector to
"BROIL". "HI" will show on display. Press
"Enter". Look through oven window. The
top element should glow red and heat
should be radiating out of the door. Press
"Cancel" and turn oven selector to
"Reset".
If the oven does not operate, check that
power supply is turned on, that no fuses
are blown, or circuit breakers tripped. If
the oven still does not operate, contact
your KitchenAid dealer or designated
service company.
21.
Reinstall lower vent by
inserting tabs into the slots on the front
trim. Push vent upward until the holes line
up at top of vent. Reattach the vent using
the two screws.
22.
Place burner grates over
burner caps. The simmer plate may set
on one of the grates or be stored for
future use. (See Use and Care Guide.)
To get the most efficient use
from your new dual fuel range,
read your KitchenAid Use and
Care Guide. Keep Installation
Instructions and Guide close
to the range for easy
reference.
8
Installer checkoff
list:
RANGE
Range correctly positioned in
countertop cutout.
Maintained specified distances to
cabinet surfaces.
Range level – front to back – side to
side.
Burner caps positioned properly on
sealed burner bases.
All packing material removed.
Backguard attached (if horizontal
clearance to combustible materials
behind cooking surface is less than
1" (25.4 mm).
GAS SUPPLY
The range is connected only to type
of gas for which it is certified for use.
If range
does not operate:
Check that the circuit breaker is not
tripped or the house fuse blown.
Check that gas valves are turned to
the "ON" position.
See Use and Care Guide for
troubleshooting list.
If you need
assistance:
The KitchenAid Customer Interaction
Center will answer any questions about
operating or maintaining your range not
covered in the Installation Instructions.
The KitchenAid Customer Interaction
Center is open 24 hours a day, 7 days a
week. Just dial 1-800-422-1230 — the
call is free within the continental United
States, or visit our web site at
www.kitchenaid,com.
When you call, you will need the range
model number and serial number. Both
numbers can be found on the
model/serial rating plate located on the
surface below the control panel.
If you need
service:
In the event that your KitchenAid appliance
should need service, call the dealer from
whom you purchased the appliance or a
KitchenAid-designated service company. A
KitchenAid-designated service company is
listed in the Yellow Pages of your telephone
directory under "Appliances — Household —
Major — Service and Repair."
You can also obtain the service company's
name and number by dialing, free within the
continental United States, the KitchenAid
Customer Interaction Center telephone
number, 1-800-422-1230. A special operator
will tell you the name of your nearest
KitchenAid-designated service company.
Maintain the quality built into your KitchenAid
appliance — call a KitchenAid-designated
service company.

Maintenance:

If removing the range is necessary for
maintenance, shut off gas supply.
Disconnect the gas and electric supply.
Finish removing the range.