Convection Roast - KitchenAid KEHU309SSS Use & Care Manual

Built-in electric convection oven with steam assist
Hide thumbs Also See for KEHU309SSS:
Table of Contents

Advertisement

Available languages

Available languages

5. To use the temperature probe, touch PROBE and enter the
desired food temperature using the number keys.
6. Once a cooking setup function is complete, the Start key will
light up.
7. When settings are correct, touch START.
8. During the preheat and cooking cycle an Adjust Settings key
appears on the lower right hand corner of the display. Touch
ADJUST SETTINGS to change the desired time, temperature
and/or probe settings. Touch START to enter new settings.
9. If the oven temperature is below the set temperature, the
Preheat Bar will be displayed showing the status of the
preheat cycle. When preheat is complete a tone will sound.
10. If the Cook Time has been set or the temperature probe has
been used, the Check Food message will appear at the end
of the cook time or once the set temperature has been
reached.
If enabled, end-of-cycle tones will sound, then reminder
tones will sound every minute. Touch OK to clear the
message, stop reminder tones, and continue the current
cooking cycle.
11. Touch OFF when finished cooking.

Convection Roast

WARNING
Burn Hazard
Use an oven mitt to remove temperature probe.
Do not touch broil element.
Failure to follow these instructions can result in burns.
Convection roasting can be used for roasting meats and poultry,
or for baking yeast breads and loaf cakes using a single rack.
During convection roasting, the broil, convect, and CleanBake™
elements will cycle on and off in intervals to maintain oven
temperature, while the fan constantly circulates the hot air.
A
B
C
A. Broil heat
B. Convection fan
C. Bake heat
If the oven door is opened during convection roasting, the fan
turns off immediately when the door is opened and turns on
immediately when the door is closed. Bake, broil, and convect
elements will turn off approximately 30 seconds after the door is
opened. They will turn on again approximately 30 seconds after
the door is closed.
Reduce recipe temperature 25°F (14°C). The cook time may
need to be reduced also.
For best results, use a broiler pan, grid and roasting rack,
designed to drain juices and help avoid spatter and smoke.
If you would like to purchase a Broiler Pan Kit, it may be
ordered. See "Assistance or Service" section to order. Ask for
Part Number W10123240.
To Convection Roast:
Before convection roasting, position racks according to the
"Positioning Racks and Bakeware" section. It is not necessary to
wait for the oven to preheat before putting food in, unless
recommended in the recipe.
Use the roasting rack on top of the broiler pan and grid. This
holds the food above the grid and allows air to circulate
completely around all surfaces.
If you would like to purchase a Broiler Pan Kit, it may be ordered.
See "Assistance or Service" section to order. Ask for Part
Number W10123240.
A. Roasting rack
B. Broiler grid
C. Broil pan
1. From the Main menu, touch CONVECT.
2. Touch ROAST.
3. To change the preset temperature, enter the desired
temperature on the number keys. The convection roast
temperature can be set between 170°F and 500°F (77°C and
260°C).
4. To change the cook time, touch COOK TIME. Enter the
desired cook time using the number keys.
5. To use the temperature probe, touch PROBE and enter the
desired food temperature using the number keys.
6. Once a cooking setup function is complete, the Start key will
light up.
7. When settings are correct, touch START.
8. During the preheat and cooking cycle an Adjust Settings key
appears on the lower right hand corner of the display. Touch
ADJUST SETTINGS to change the desired time, temperature
and/or probe settings. Touch START to enter new settings.
9. If the oven temperature is below the set temperature, the
Preheat Bar will be displayed showing the status of the
preheat cycle. When preheat is complete a tone will sound.
10. If the Cook Time has been set or the temperature probe has
been used, the Check Food message will appear at the end
of the cook time or once the set temperature has been
reached.
If enabled, end-of-cycle tones will sound, then reminder
tones will sound every minute. Touch OK to clear the
message, stop reminder tones, and continue the current
cooking cycle.
11. Touch OFF when finished cooking.
A
B
C
17

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Kehu309

Table of Contents