Locate Wall Stud(S) - KitchenAid Architect Series II KHMS1850S Installation Instructions Manual

Microwave hood combination
Hide thumbs Also See for Architect Series II KHMS1850S:
Table of Contents

Advertisement

NOTE: If no wall studs exist within the cabinet opening, do not
install the microwave oven.
See illustrations in "Possible Wall Stud Configurations."
Possible Wall Stud Configurations
These depictions show examples of preferred installation configurations with the mounting plate.
No Wall Studs at Corner Holes
B
C
A
E
F
Wall Stud at One Corner Hole
B
A
E
C
F
6

Locate Wall Stud(s)

Figure 1
Figure 3
A. Corner holes (on mounting plate)
B. Cabinet opening vertical centerline
C. Wall stud centerlines
D. Holes for lag screws
E. Support tabs
F. Mounting plate center markers
1. Using a stud finder, locate the edges of the wall stud(s) within
the opening.
2. Mark the center of each stud, and draw a plumb line down
each stud center. See illustrations in "Possible Wall Stud
Configurations."
No Wall Studs at Corner Holes
C
B
D
A
A
E
E
F
NOTE: If wall stud is within 6" (15.2 cm) of the vertical
centerline (see "Mark Rear Wall" section), only recirculation or
roof venting installation can be done.
Wall Studs at Both Corner Holes
D
B
A,D
A,D
E
E
C
C
F
Figure 2
Figure 4
C
D
A
E
A,D
E
C

Advertisement

Table of Contents
loading

Table of Contents