Table of Contents
Advertisement
CABLE CONTROL
The hand controller is normally used in radio mode
but it is also possible to operate it via a cable.
A four-metre cable (E0781) is supplied as standard with
the hand controller. The cable is intended to be used for
short-term operation and when pairing in conjunction
with the replacement of hand controllers or decoders.
The cable connects to the vehicle via the decoder's left-
hand CAN bus connector. (See Figure 3)
If the hand controller is to be wired permanently or for
a long period, an adapter cable (E0837) is run from the
PDB and installed at a suitable location on the vehicle.
To give the operator greater freedom of movement, a
15-metre cable (E0782) is used between the adapter and
the controller. (See Figure 4)
When the cable is connected to the hand controller,
the centre display shows that the controller is in cable
operation mode. The symbols for signal strength (radio)
and battery capacity are replaced with the symbol for
cable operation. (See Figure 5)
Figure 3
ENGAGE MANUAL EXTENSION
This function must be activated so that the safety system
can calculate the capacity when manual extension is used.
This is done by pressing the release and horn buttons at
the same time until the manual extension symbol appears
on the centre display.
Use the same procedure to disengage the manual exten-
sion function.
17
Figure 5
Figure 4
Advertisement
Table of Contents
