Table of Contents
Advertisement
Connection
Connecting the Power Cord
The internal power supply will support 100 - 240 VAC (Auto Sensing). The power
cord shipped with the router is a 120 VAC three-conductor power cord for use in the
United States and Canada. If the router is being installed outside the United States or
Canada, the appropriate power cord should be purchased.
To connect the power cord to the router:
1. Connect the power cord to the power connector on the back-side of the router.
2. Connect the power cord to a grounded voltage source.
Figure 3-1: Power connector
WARNING: To reduce the risk of electric shock or damage to the equipment:
•
•
•
3-2
Serial
Pwr.
Do not disable the power-cord grounding plug. The grounding plug is an
important safety feature.
Plug the power cord into a grounded (earthed) electrical outlet that is easily
accessible at all times.
Disconnect power from the router by unplugging the power cord from
either the electrical outlet or the router.
Ethernet
Link/
Act
0
1
LVD/SE SCSl
Fibre Channel
Network Storage Router N1200 Installation Guide
Advertisement
Table of Contents
