Attaching Inner Rails To The Router - Compaq StorageWorks Storage Router N1200 Installation Manual

Installation
5. Attach an inner rail to each side of the router.
See Figure 2-3 for an illustration.
a. With the spring latch facing away from the router and the circular grasping
hole facing the front-side of the router, align the front-most screw hole on the
router with the center screw hole on the rail.
NOTE: The front-side of the router has air vents, as illustrated in Figure 2-3. The
back-side of the router has all of the interconnects.
Using this alignment, two screw holes will be aligned and the rail will extend
out from the front-side of the router approximately 8 inches.
b. Secure the rail to the router using two #6-32x.312 Phillips screws.
Back End
Figure 2-3: Attaching inner rails to the router
c. Repeat Step 5 to attach the inner rail to the other side of the router.
6. Install the router in the rack.
See Figure 2-4 for an illustration.
a. Move the ball-bearing slide on each of the outer rails towards the front of the
rack.
b. From the front-side of the rack with the front-side of the router facing out,
align the inner and the outer rails and slide the inner rail into the outer rail.
2-6
Spring Latch
Inner Rail
Front End
Network Storage Router N1200 Installation Guide