Advertisement
This push-button moves the cursor right ► when navigating through menus and settings. It is also used to reset
the fault indication on the fascia e.g. lit LEDs. When on the relay identifier screen it can also act as an LED test
button. When pressed, all programmable LEDs will momentarily light up to indicate their correct operation.
7SR157
____________________________
SETTINGS MODE
SYSTEM CONFIG
CT/VT CONFIG
FUNCTION CONFIG
CONTROL AND LOGIC
SUPERVISION
INPUT CONFIG
OUTPUT CONFIG
DATA STORAGE
COMMUNICATIONS
© 2016 Siemens Protection Devices Limited
CLOSE CCT SUPERVISION
VT SUPERVISION
VOLTAGE SETTING MENU
CHECK SYNC MENU
SYSTEM SYNC MENU
QUICK LOGIC
VT SUPERVISION
DEMAND
CLOSE CCT SUPERVIS'N
INPUT MATRIX
BINARY INPUT CONFIG
GENERAL ALARMS
OUTPUT MATRIX
BINARY OUTPUT CONFIG
LED CONFIG
PICK UP CONFIG
TRIP CONFIG
DEMAND / DATA LOG
WAVEFORM STORAGE
FAULT STORAGE
ENERGY STORAGE
Figure 1-4 Menu Structure
Chapter 2 - 7SR157 Settings and Instruments
INSTRUMENTS MODE
FAVOURITE METERS
VOLTAGE METERS
SYNC METERS
DEMAND METERS
GENERAL ALARM METERS
BINARY INPUT METERS
BINARY OUTPUT METERS
VIRTUAL METERS
COMMUNICATION METERS
MISCELLANEOUS METERS
QUICK LOGIC METERS
Chapter 2 - Page 5 of 14
FAULT DATA MODE
NUMBER OF FAULTS
Advertisement
Chapters
