Advertisement
Please read and understand setup guide prior to installing the Electric Actuator!
**Grounding the electric actuator wiring harness to the frame of the tow vehicle may prevent the electric
actuator, or other components; from working properly. Always ground the wiring harness directly to the
tow vehicle battery.
**When securing the wiring harness to the tow vehicle avoid areas around any major heat zones such as:
Mufflers, Muffler pipes, radiators, exhaust manifolds, or other high heat areas on the tow vehicle.
**When securing the wiring harness to the tow vehicle avoid all pinch point areas such as: between the
seat of the tow vehicle and the frame, shocks, moving/pivoting parts, dump beds, doors, and other areas
where the wiring harness my become smashed, cut, ripped, or torn.
Assembling the Rocker Switch:
The Rocker switch may be attached at any time during the setup procedure. If working alone we
recommend installing the switch to the tow vehicle last, so that the switch may be used later in the
assembly process.
1. To assemble the rocker switch for mounting to the tow vehicle locate the bag containing the rocker
switch, bracket, and hardware. See figure below.
Figure
3
2. Attach the L shaped bracket to the rocker switch using the two elongated screws coming out the back
of the switch. Use a 7mm Socket and Wrench to secure the two black nuts to the screws.
Figure
4
ABI
-‐
8 55-‐211-‐0598
-‐
w ww.abiattachments.com
( Absolute
I nnovations,
I nc.)
Advertisement
