Related Manuals for abi SR2 COMMAND Series
Summary of Contents for abi SR2 COMMAND Series
- Page 1 Skid Steer Attachment Setup/User Guide Please read fully and understand before operating!! 1320 Third Street – Osceola, IN 46514 – 855-211-0598 (Absolute Innovations, Inc.) - www.abicommandseries.com...
-
Page 2: Contact Information
Please read fully and understand before operating!! Thank You, On behalf of the ABI family we would like to thank you for your recent purchase of your SR2 Skid Steer Attachment. Our Company’s goal is to provide you, our customer; with innovative, quality tools as well as first rate customer service. -
Page 3: Operational Safety Rules
Please exercise caution at all times when setting up, operating, or performing maintenance on the ABI SR2. Remember, any piece of equipment like the ABI SR2 can cause injury if operated improperly or if the user does not understand how to operate the equipment. Exercise caution at all times with using the ABI Force. -
Page 4: Setup And Operations
Please read fully and understand before operating!! Setup and Operations - Removing from Shipping Crate: Tools Needed: Crow Bar/Pry Bar Metal Snips Transport the SR2 in the shipping crate to a level firm surface. Using a crow bar/pry bar remove the top and sides from the shipping crate. - Page 5 Please read fully and understand before operating!! 3. Engage the parking brake and stop the engine. 4. Lift the latch handles fully to ensure the lock pins are fully retracted. 5. With the latch handles fully retracted, tilt the mounting plate forward while slowly backing away from the SR2. NOTE TO OPERATOR: Some Skid Steer models may have special disconnect requirements.
- Page 6 Please read fully and understand before operating!! 8. With the wheels of the SR2 touching the ground, continue to back up 4-5’ to ensure the full depth of the scarifiers is reached. 9. Stop the Skid Steer, set the parking brake, shut off the engine and exit the Skid Steer. 10.
- Page 7 Please read fully and understand before operating!! Setting Scarifier Depth with Hydraulic Scarifiers: 1. Transport the SR2 to an area where the attachment will be used. 2. Lower the SR2 until the wheels and finish rake touch the ground at the same time. The SR2 may need to be backed up slightly to allow the scarifiers to penetrate the surface with the hydraulic scarifiers attached.
-
Page 8: Maintenance
Check hardware daily to ensure that nuts and bolts are tight, and that pins are properly secured. If any hardware is found to be damaged replace hardware prior to operating the SR2 The hubs will need to be repacked every 6 months. ABI recommends using a Hi-Temp Grease for packing the bearings inside the hubs. ... - Page 9 Please read fully and understand before operating!! For additional setup or usage questions feel free to contact ABI’s Customer Service Staff at 855-211-0598 M-Th 8am-8pm or Friday 8am-5pm EST. Additional information on the SR2 is available on the ABI support page at www.abisupport.com.