Advertisement
Please read and understand setup guide prior to installing the Electric Actuator!
Attaching the ATV Side Wiring Harness –
1. Using cable ties, or other means; loosely secure the 4 prong cable with split ends to the frame of the
tow vehicle. When securing the wiring harness to the tow vehicle make sure to avoid any areas of high
heat or pinch points to prevent any damage to the wiring harness. Make sure the 4 prong end is coming
out the back of the tow vehicle. See figure below for reference.
Figure
1
2. Locate the two provided ring terminals, and secure them to the ends of the Black and White wires on
the end of the 4 prong cable. To secure the ring terminals, insert the wire into the open end of the ring
terminal. See Figure 2. Using either a pair of pliers, or a crimper; squeeze the blue cover down securing
the wires to the ring terminals. See figure below for reference.
Figure
2
3. Now secure the wires directly to the battery of the tow vehicle. Ensure that the Black wire is secured to
the positive side of the battery, and the white wire is secured to the negative side of the battery.
4. Once the wiring harness is secured to the battery the remainder of the wiring harness can be firmly
secured to the tow vehicle. Ensure that enough slack is left for the three prong connector to reach the front
of the tow vehicle, as well as some slack on the wires going to the battery.
If you are not comfortable working with electrical wiring, we strongly encourage you to seek the help of
someone with experience wiring.
**The electric actuator wiring harness must be hooked directly to the battery of a tow vehicle. Ensure
that when the electric actuator wiring harness is fully secured to the tow vehicle battery, that the black
wire is secured directly to the positive side, and that the white wire is secured directly to the negative
side.
ABI
-‐
8 55-‐211-‐0598
-‐
w ww.abiattachments.com
( Absolute
I nnovations,
I nc.)
Advertisement
