ABB ACS880-01 Hardware Manual page 7

Additional requirements for ABB motors of types other than M2_,
M3_, M4_, HX_ and AM_ .................................................................
Additional requirements for braking applications ..............................
Additional requirements for ABB high-output and IP23 motors ........
Additional requirements for non-ABB high-output and IP23 motors ..
Additional data for calculating the rise time and the peak line-to-line
voltage ..............................................................................................
Additional note for sine filters ...........................................................
Selecting the power cables .................................................................................
General guidelines .......................................................................................
Typical power cable sizes ............................................................................
Power cable types ........................................................................................
Preferred power cable types .............................................................
Alternate power cable types .............................................................
Not allowed power cable types .........................................................
Additional guidelines, North America ...........................................................
Metal conduit ....................................................................................
Power cable shield .......................................................................................
Selecting the control cables ................................................................................
Shielding ......................................................................................................
Signals in separate cables ...........................................................................
Signals that can be run in the same cable ...................................................
Relay cable ..................................................................................................
Control panel to drive cable .........................................................................
PC tool cable ................................................................................................
Routing the cables ..............................................................................................
General guidelines - IEC .............................................................................
General guidelines - North America ............................................................
Continuous motor cable shield/conduit or enclosure for equipment on the
motor cable ..................................................................................................
Separate control cable ducts .......................................................................
Implementing short-circuit and thermal overload protection ...............................
Protecting the drive and the input power cable in short-circuits ...................
Protecting the motor and motor cable in short-circuits .................................
Protecting the motor cables against thermal overload .................................
Protecting the motor against thermal overload ............................................
Protecting the motor against overload without thermal model or temperature
sensors using an external overload device ..................................................
Protecting the drive against ground faults ..........................................................
Residual current device compatibility ...........................................................
Connecting drives to a common DC system .......................................................
Implementing the emergency stop function ........................................................
Implementing the Safe torque off function ..........................................................
Implementing the functions provided by the FSO-xx safety functions module ....
Implementing an ATEX-certified motor thermal protection .................................
Table of contents 7
66
66
66
67
68
69
69
69
70
71
71
72
73
73
74
74
75
75
75
75
75
75
75
76
76
76
77
78
78
78
79
79
79
79
80
80
80
80
80
80
81