Advertisement
Step 8
å
Separate the EXTENSION SLIDES (35MC) from the EXTENSION RAILS (35MA) as
shown in the upper diagram below. Be prepared, the parts are greasy.
å
Fasten the EXTENSION RAILS (35MA) to the LEFT END (B) and UPRIGHT (D). Use four
GOLD 5/16" FLAT HEAD SCREWS (3S) through holes #1 and #3.
å
NOTE: For each EXTENSION RAIL, turn a SCREW into the hole shown in the enlarged
diagram. Then, slide the inner cartridge of the EXTENSION RAIL in to find the other hole
that lines up with the hole in the END or UPRIGHT. Turn a SCREW into this hole.
å
NOTE: The EXTENSION SLIDES (35MC) will be used later for the DRAWER.
Push the black lever in and pull the SLIDE from the RAIL.
Open end
1
2
35MC
B
3
GOLD 5/16" FLAT HEAD SCREW
Short edge with
HIDDEN CAMS
3
2
1
35MA
3S
(4 used for the RAILS)
D
Open end
Page 13
Advertisement
