Safety Guidelines For Battery Chargers; Original Accessories/Attachments; Before Use; Charging The Battery Pack (See Fig. I) - Parkside PPHA 20-Li B2 Translation Of The Original Instructions

Safety guidelines for battery chargers

This tool may be used by children
■
aged 8 years and above and
by persons with limited physical,
sensory or mental capabilities or
lack of experience and knowl-
edge, provided that they are
under supervision or have been
told how to use the tool safely
and are aware of the potential
risks. Do not allow children to use
the tool as a toy. Cleaning and
user maintenance tasks may not
be carried out by children unless
they are supervised.
To avoid potential risks, if the
■
appliance power cable is dam-
aged, it must be replaced by the
manufacturer, its customer service
or by a qualified technician.
The charger is suitable for indoor use only.
WARNING!
■ If the mains cable requires replacement, this
should be carried out by the manufacturer or
an approved representative to avoid safety
hazards.
ATTENTION!
♦ This charger can only charge the following
batteries: PAP 20 A1/PAP 20 A2/
PAP 20 A3/PAP 20 B1/PAP 20 B3/
PAPS 204 A1/PAPS 208 A1.
♦ A current list of battery compatibility can
be found at www.Lidl.de/Akku.
PPHA 20-Li B2

Original accessories/attachments

■ Use only the accessories and additional
equipment that are specified in the operat-
ing instructions and are compatible with
the appliance. Using attachments or accessory
tools other than those recommended in the
operating instructions can lead to a risk of
injury.

Before use

Charging the battery pack (see fig. I)
CAUTION!
► Always unplug the charger before you
remove the battery pack
to the charger.
NOTE
► Never charge the battery pack
ambient temperature is below 10°C or
above 40°C. If a lithium-ion battery is to be
stored for an extended period, the charge
level should be checked regularly. The opti-
mum charge level is between 50% and 80%.
The storage climate should be cool and dry,
and the ambient temperature should be
between 0°C and 50°C.
♦ Insert the battery pack
charger (see fig. I).
♦ Insert the power plug into the socket.
The control LED lights up red.
♦ The green control LED
charging process is complete and the battery
pack is ready for use.
ATTENTION!
♦ If the red control LED
that the battery pack
cannot be charged.
♦ If the red and green control LEDs
flash, this means that the battery pack
defective.
from or connect it
when the
into the high-speed
indicates that the
flashes, this means
has overheated and
both
is
GB │ CY
│
7 ■