Replacing The Drive Belt (See Fig. F); Maintenance And Cleaning - Parkside PPHA 20-Li B2 Translation Of The Original Instructions

♦ Push the movable cutter block guard
slot in the housing.
♦ Push the planing blade
clamping element
NOTE
► The planing blade
with protective lacquer. It is not necessary to
re-bond the blade.
♦ Fit either a new or turned blade in the reverse
order. Make sure that the notch on the planing
blade slides into the tensioning plate
groove (see fig. E).
20a
♦ Make sure that the planing blade
a little way (approx. 1 mm) from the cutter
block in the direction of the movable lateral
cutter block guard
block to check that the planing blade does not
scrape anywhere.
♦ Also ensure that the clamping element
flush to the cutter block
ment must lie on the hex screws
the fastening screws
♦ Planing blades can be purchased exclusively
from the address given below (see section
"Service"). Do not use planing blades from
other manufacturers.
Setting the planing blade height
♦ Set the cutting depth to 0 mm.
♦ Check the position of the planing blade
both ends. Use a flat, straight object as a guide
strip over the plane sole
♦ The tip of the planing blade
with the surface of the plane sole
♦ The height of the planing blade
adjusted using the hex key
screws . Adjust the two hex screws
the tip of the planing blade is flush with the
plane sole on both sides.
10
GB │ CY
│
■
into the
sideways out of the
(see fig. D)
may be factory-bonded
protrudes
. Carefully turn the cutter
closes
. The clamping ele-
before
can be tightened.
at
.
must be flush
.
can be
via the two hex
so that
Replacing the drive belt (see fig. F)
RISK OF INJURY!
► Always switch the appliance off and remove
the battery pack
work on the appliance.
♦ Remove the screws
belt cover .
♦ Remove the worn drive belt
♦ Fit the new drive belt
wheel first and then turn the drive belt
and pull it onto the large belt wheel
♦ Replace the drive belt cover
place using the screws

Maintenance and cleaning

WARNING! RISK OF INJURY! Always
switch the appliance off and remove
the battery before carrying out any
work on the appliance.
♦ Keep the appliance and the ventilation slits
clean to ensure fault-free operation.
♦ Clean the chip ejector
♦ To clean a blocked chip ejector, use a suitable
tool (e.g. a piece of wood, compressed air, etc.).
♦ Use a dry cloth to clean the housing.
♦ Use a brush to remove any dust stuck to the
appliance.
♦ Never use sharp objects, petrol, solvents or
cleansers which can damage plastic. Do not
allow any liquids to get into the interior of the
appliance.
WARNING!
■ Do not use any accessories that are not
recommended by PARKSIDE. This can lead
to an electric shock and fire.
NOTE
► Replacement parts that are not listed (such as
batteries, rip fence or fold depth stop) can be
ordered via our Service Hotline.
before carrying out any
and detach the drive
.
onto the small belt
.
and fix it in
.
regularly.
PPHA 20-Li B2