RIDGID R4093 Operator's Manual page 13

ASSEMBLY
 Place a large spacer over the end of the lower brace.
 Insert a hex bolt through the bottom of the right outer
tube, the large spacer, and into the lower brace. Tighten
securely. Repeat for the other side.
 With the curved ends turned downward, secure the
upper tubes to the WSUV stand using carriage bolts,
small spacers, and nuts.
NOTE: The upper tube with the tab should be installed
on the right.
RIGHT
OUTER TUBE
LOWER
BRACE
LARGE
SPACER
HEX
BOLT
RIGHT
UPPER TUBE
TAB
CENTER
BRACE
LEFT
UPPER TUBE
LEFT
OUTER TUBE
CARRIAGE
SMALL
BOLT
SPACERS
NUT
INNER LEG
ASSEMBLY
 Slide a large washer, wheel, and small washer onto an
axle. Secure in place using nut. Repeat with the second
wheel.
 Insert the rear crossbar into the openings on the end of
the frame as shown. Push firmly into place.
NOTE: The long end of the crossbar should be on the
right when facing the rear of the saw.
Fig. 12
Fig. 13
13 — English
AXLE
WHEEL
SMALL
WASHER
NUT
LARGE
WASHER
Fig. 14
REAR
CROSSBAR
Fig. 15