Utility Solutions Jack Jumper USJJ-006 Manual

Product Description
The Jack Jumper Cutout Bypass Tool permits a safe and quick method to
®
bypass an overhead cutout without the tedious use of bulky jumper cables. The
tool is indispensable for fuse coordination tasks and permits easy bypass of an
underground dip. The Jack Jumper
eliminates risk of service interruption and prevents accidental cross phasing.
The primary purpose of the Jack Jumper
bypass a cutout fuse door during fuse coordination. The Jack Jumper
Bypass Tool is rated at 100 Amps continuous AC current without exceeding a
40°C temperature rise. It is used to bypass cutouts on both overhead lines and
underground taps.
The USJJ-006 can be used in parallel on SMD-20 and S9CMU Power Fuse
cutouts. For 200 Ampere attach a Jack Jumper
Parallel operation limited to only Power Fuse cutouts and cannot be utilized for
standard cutouts.
Installation and removal of the Jack Jumper
shotgun stick.
Perpendicular Ring
Spring
Mechanism
In-Line Ring
Phone (828) 323-8914
Email
sales@utilitysolutionsinc.com
Web
www.utilitysolutionsinc.com
101 33 Street Drive SE · Hickory, NC 28602
rd
Jack Jumper
27kV SMD-20 Cutout Bypass Tool
27kV S9CMU Fuse Bypass Tool
Cutout Bypass Tool saves time and money,
®
Cutout Bypass Tool is to temporarily
®
Cutout Bypass Tool on each side.
®
Cutout Bypass Tool is done with a
®
Attachment Hook
Attachment Hook
© 2018-2022 Utility Solutions Inc.
C-01094 USJJ-006 Instruction Manual (9-12-22)
Cutout Bypass Tool
®
USJJ-006
Cutout
®
DANGER
!
Contact with high voltage will cause death or grievous
personal injury to the operator. Only use this device in
conjunction with safe operating practices around energized
lines and equipment.
WARNING
!
Carefully read and fully understand the INSTRUCTION
MANUAL prior to operating, maintaining or testing this device.
Improper operation, handling or maintenance of this device
can result in death, grievous personal injury and or equipment
damage.
WARNING
!
Follow safe work procedures and practices when utilizing this
device. Failure to use this device in a safe manner can result
in death, grievous personal injury and or equipment damage.
WARNING
!
Only trained and qualified personnel should operate, inspect
and maintain this device.
WARNING
!
Only install the Jack Jumper Cutout Bypass Tool with the use
®
of an insulated shotgun stick. When attaching or detaching
the Jack Jumper Cutout Bypass Tool do not use abrupt or
®
rough movements, be gentle and do not hurry.
WARNING
!
These instructions are not intended to replace or be a
substitute for proper safety training procedures. Failure
to select the proper tool in regards to minimum system
requirements can result in death, grievous personal injury and
or equipment damage.
WARNING
!
Never install or remove a Jack Jumper
on an open cutout.
WARNING
!
If you are servicing a fuse, replace the fuse as quickly as
possible. The fuse is a protective device. The Jack Jumper
Cutout Bypass Tool DOES NOT FUNCTION AS A FUSE.
If you must leave the area, replace any fuses and remove
the Jack Jumper Cutout Bypass Tool. It is not a fuse
®
replacement or permanent by-pass mechanism.
!
!
!
!
!
!
!
Cutout Bypass Tool
®
!
®